VSC Compact Air Handling Unit Installation instructions GB V1 (1/2)
Topvex FC Compact Air Handling Unit © Copyright Systemair AB All rights reserved E&OE Systemair AB reserves the rights to alter their products without notice. This also applies to products already ordered, as long as it does not affect the previously agreed specifications.
Contents Topvex FC 1 Warnings........................................................................................................................................................... 4 2 Product information........................................................................................................................................... 4 2.1 General ..................................................................................................................................... 2 2.
1 Warnings Topvex FC The following admonitions will be presented in the different sections of the document: Danger • Compact Air Handling Unit Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious injury. Warning • Indicates a potentially hazardous situation that may result in minor or moderate injuries. Caution • Indicates a risk of damaging the product or prevent optimal operation.
2.2 Technical data 2.2.
524 500 1700 250 274 380 390 21 Topvex FC Compact Air Handling Unit 720 1400 323 1270 323 625 625 323 1305 323 1630 Model Weight, kg VSC 1500 VSC 1500 EL VSC 1500 HW 165 170 170 Operation and Maintenance Instructions Operation and Maintenance Instructions Document in original 6 language 125918-EN_GBSystemair AB 2015-03-16 A001
624 600 2000 300 324 460 470 21 Topvex FC Compact Air Handling Unit 902 1728 433 1600 433 735 735 433 1630 433 1630 Model VSC 2000 VSC 2000 EL VSC 2000 HW Weight, kg 240 245 245 Operation and Maintenance Instructions Operation and Maintenance Instructions Document in original 7 language 125918-EN_GBSystemair AB 2015-03-16 A001
2.2.
2.2.3 Electrical data VSC Topvex FC Model Fans (W tot.) 230V 1~ El Heating battery (kW tot.) Fuse (mains) (A) for 230V 1~ and 400V 3~ VSC 700 EL 330 VSC 700 None, HW 1,4 16 Compact Air Handling Unit 330 - 10 VSC 1500 EL 910 2,7 25 VSC 1500 None, HW 910 - 10 VSC 2000 EL 1000 4,8 3x16 VSC 2000 None, HW 1000 - 10 2.3 Transport and storage VSC is delivered in one piece on a pallet for easy transportation using a forklift.
NOTE: Necessary parts like control panel, supply air sensor, handles, drainage pipe with drain trap are placed loosely inside the unit. The unit must not be put into operation before the enclosed parts are removed and installed properly. Warning • • Topvex FC Compact Air Handling Unit The unit is heavy. Be careful during transport and mounting. Risk of injury through pinching. Use protective clothing. Be careful so the unit don‘t tip over.
3.3 Condensation drain The unit must be connected to the condensation drain. See table 1 how the height “H” corresponds to different maximum negative pressures. If the unit is mounted in a tight area that makes it difficult to have the appropriate height, a pump is available as an accessory. Topvex FC Note: When installed in a non heated place the drain pipe and trap needs to be insulated well to prevent the water from freezing. Compact Air Handling Unit Fig. 3 H Fig.
3.4 Installing the unit The units are designed for ceiling installation Topvex FC Compact Air Handling Unit SUP ODA ETA ETA Fig.
3.4.1 Installation procedure The units are designed for ceiling installation Warning • Topvex FC Compact Air Handling Unit Beware of sharp edges during mounting and maintenance. Make sure that a proper lifting device is used. Use protective clothing. Warning • The units electrical connection to the mains power supply must be preceded by an all pole circuit breaker with a minimum 3 mm gap.
3.5 Connections 3.5.1 Ducting Topvex FC 5 8 1 6 Compact Air Handling Unit SUP 3 ODA 2 4 ETA ETA Fig.
3.5.2 Condensation and heat insulation Topvex FC on ducts connected to the unit is especially important. All ducts installed in cold rooms/areas must be well insulated. Use insulating covering (minimum 100 mm mineral wool) with plastic diffusion barrier. In areas with extremely low outdoor temperatures during the winter, additional insulation must be installed. Total insulation thickness must be at least 150 mm.
Topvex FC Compact Air Handling Unit Fig. 7 VSC units are equipped with a built in regulator. 4 7 8 1 2 9 5 3 6 Fig.
3.5.
3.5.6 BMS Connection Communication possibilities for control unit.
Systemair AB reserves the right to make changes and improvements to the contents of this manual without prior notice. Systemair AB Unit 28, Gravelly Industrial Park, Birmingham, B24 8HZ Tel: +44 (0) 121 322 0200 Fax: +44 (0) 121 322 0201 Emal: info@systemair.co.
