Configuration Manual

Version Document
A
001
A
ccess V4.X Configuration manual
43 (56) 2018-07-11
related to any control functions. “Extra Sensor 1” should be used for external
setpoint input.
Extra alarm
 No
 Yes
If selection are yes, 1..10 extra alarm can be configured under I/O allocation
I/O allocation settings
Configure: Configuration
22.1 Analog inputs
Configure: Configuration > I/O allocation
Analog inputs shows only sensors/signals that are activated by configuration
Note! If the sensor/signal is not in the list, please activate and configure the function and
go back in this list to set up a physical position of I/O’s
Analouge inputs Device Signal
e.g Supply air temperature Controller AI1
Avalible analogues inputs
 Outdoor temperature
 Intake air temperature
 Supply air temperature
 Exhaust air temperature
 Extract air temperature
 Room temperature 1
 Room temperature 2
 Room temperature 3
 Room temperature 4
 Pressure supply air
 Pressure extract air
 Flow supply air
 Flow extract air
 Flow exchanger supply air
 Pressure exchanger extract air
 Defrosting temperature
 Frost protection temperature 1
 Frost protection temperature 2
 Frost protection temperature 3
 CO2 room/extract air
 Humidity sensor room/extract air
 Humidity sensor supply air
 Humidity outdoor
 Extra controller temperature
 External control supply air fan
 External control extract air fan
 Extra sensor 1
 Extra sensor 2
 Extra sensor 3
 Extra sensor 4
 Extra sensor 5
 External setpoint temperature
 External setpoint flow
 Pressure filter supply air
 Pressure filter extract air
 Efficiency temperature exchanger
Device
Select controller or some off the other device.
Note! If you not find your device, se 25.2 to configure/activate your device
Signal
Select I/O for signal on selected device.
Note! It’s possible to select an already used I/O position.
Please select the same ouputs as wiring diagram describe.
Or select a free I/O’s position.
22.2 Digital inputs
Configure: Configuration > I/O allocation
Digital inputs shows only sensors/signals that are activated by configuration