Configuration Manual

Version Document

001

ccess V4.X Configuration manual

23 (56) 2018-07-11

settings. Therefore, Blocking step 1 will apply to binary steps 1 and 2, Blocking

step 2 to binary steps 3 and 4, and Blocking step 3 to binary steps 5, 6 and 7.

Blocking of DX cooling on cooling pump alarm Corrigo can be configured to block

DX cooling on cooling pump alarm. In- and outputs

Override of reduced speed for DX cooling

Override to normal quantity of air for DX cooling when the unit runs on reduced

quantity of air. The fans can be set to normal operation when cooling is required at

high outdoor temperatures (e.g. >14°C, the same temperature limit as for blocking

of DX cooling).

Step controller

Activate: By configuring Cooler DX, the step switch will be activated in the menu.

Configure: Configuration > Function Configuration > Function Activation> Sequence Configure

type > Step controller 1 (Step controller 2)

Step controller 1 (2)

Input

 Select sequence to connect to step controller 1

Step control type

 Sequenciel

 Binary

Number of step

 1

 2

 3

 4

Select number of digital outputs

Hysteresis if low outdoor temperature block

 1 °C

Block step signal if alam

 No

 Yes

Operation settings: Data & Settings > Temperature control > Cooling (Cooling 2)