MODBUS LITE V5.01 parameter specification

MODBUS parameters "ebm-papst series 84 / 112 / 150 / 200"
_______________________________________________________________________________________
ebm-papst Mulfingen GmbH & Co. KG
Bachmühle 2 ·74673 Mulfingen, Germany ·Phone: [phone] ·Fax: [phone] ·www.ebmpapst.com ·[e-mail]
DocNo.: 634505DocNo.: 446144DocNo.:358982DocNo.:322523DocNo.:309753DocNo.:303997DocNo.:276241DocNo.:256078DocNo.:196392 ·Template: 2 dated 6 October 2003 ·File: ext001157859.doc ·Last printed 10/03/2015 15:13:00
·Page 42 of 70
Form 1003
2.26 Limit speed
Address : D128
Write authorisation : ebm-papst
This parameter defines the limit value for the safety function "limit speed". The closed-loop speed control in
this safety function ensures that the limit speed for the impeller is not exceeded.
Encoding:
bytes Data speedLimit ]rpm[
Note:
The limit speed is not related to the maximum speed!
2.27 Potentiometer characteristic
Address of point 1 X-coordinate, parameter set 1 : D12A
Address of point 1 Y-coordinate, parameter set 1 : D12B
Address of point 2 X-coordinate, parameter set 1 : D12C
Address of point 2 Y-coordinate, parameter set 1 : D12D
Address of point 1 X-coordinate, parameter set 2 : D13C
Address of point 1 Y-coordinate, parameter set 2 : D13D
Address of point 2 X-coordinate, parameter set 2 : D13E
Address of point 2 Y-coordinate, parameter set 2 : D13F
Write authorisation : ebm-papst, customer, end customer
2 different characteristics can be defined.
The "Internal parameter set" parameter is used to select whether the "Parameter set 1" values or the
"Parameter set 2" values are applicable (see 2.13 Internal parameter set).
These parameters are used to assign a set value to the voltage at the control input.