PCA 2 1000D OPERATING INSTRUCTION25055055

2 Safety instructions
Attention!
•
Mounting, electrical connection, and start-up operation may only
be carried out by an electrical specialist in accordance with
electrotechnical regulations (e.g. DIN EN 50110 or
DIN EN 60204)!
•
Persons entrusted with the planning, installation, commissioning
and maintenance and servicing in connection with the device
must have the corresponding qualifications and skills for these
jobs. In addition, they must be knowledgeable about the safety
regulations, EU directives, rules for the prevention of accidents
and the corresponding national as well as regional and in-house
regulations.
•
It is strictly forbidden for work to be carried out on any
components while they are connected to live voltage.
•
The safe isolation from the supply must be checked using a two-
pole voltage detector.
•
The owner is obliged to ensure that the device is operated in
perfect working order only.
•
Electrical equipment must be checked regularly: Loose con-
nections are to be re-tightened and damaged lines or cables
must be replaced immediately.
•
Never clean electrical equipment with water or similar liquids.
•
A separate fault and performance monitoring-system with an
alarm signal function is necessary in order to prevent personal
injuries and material damages during malfunctions and in case
the device fails. Substitute operation must be taken into
consideration!
Intended use
These devices are intended exclusively as sensor and control
module for pressure and volume flow (non-aggressive gases
only). Their operation is only permitted under observance of the
specifications in these operating instructions.
Operating Instructions PCA-2 1000D2 Safety instructions
L-BAL-E295-GB 1906 Index 001 Part.-No.
6/48