UserManual S SA2 S SA2L202010
Table Of Contents
- Table of Contents
- Introduction
- Warnings
- Operating Conditions
- Installation
- Installation Methods
- Opening Preparation for S-SA2 Installation
- Standard Distances Between Damper Bodies
-  Installation into a Soft Crossing (up to Size 1000 × 800 mm)
- Connecting S-SA2 to “multi” Ductwork Made of Boards
- S-SA2L Installation
-  Installation on the Vertical Duct with a Ledge
-  Installation Directly on the Horizontal Duct
- Electrical Connections
- Operation Manual
- Smoke Damper Functionality Check
- Smoke Damper Inspection
- Warranty Conditions
- Operating Journal
- Warranty Service
2/40 | User Manual S-SA2 & S-SA2L | 201905 201905 | User Manual S-SA2 & S-SA2L | 3/40
Introduction
These are the original installation, inspection and operating instructions for the S-SA2 and S-SA2L smoke control dampers.
EVERY S-SA2 AND S-SA2L SMOKE DAMPER NEEDS TO BE INSTALLED IN ACCORDANCE WITH THIS DOCUMENT!
S-SA2
Rectangular smoke control damper
without mesh for wall and ceiling installations.
Dimension range (mm):
W × H = 200 × 200 up to 1600 × 1000
S-SA2L
Rectangular smoke control damper
with a mesh-tted extension suited
for vertical or horizontal duct installations.
Dimension range (mm):
W × H = 200 × 200 up to 1600 × 1000
1396-CPR-0112
1396-CPR-0147
Wet Installation
Maximum performance up to EI120S
Using concrete lling
Installation into a Soft Crossing
(up to Size 1000 × 800 mm)
Maximum performance up to EI90S
Using mineral wool lling
Installation on the Vertical Duct with a Ledge
Installation Directly on the Vertical Duct
Installation on the Horizontal Duct with a Ledge
Installation Directly on the Horizontal Duct