VAV Installation and configuration instruction Topvex SR TR SC TC SF FR FC A001

Table of content
1 Introduction .......................................................... 1
1.1 Product description ......................................1
1.2 Intended use ..............................................1
1.3 Document description...................................1
1.4 Product overview......................................... 1
2 Product liability...................................................... 1
3 Safety .................................................................1
3.1 Safety definitions......................................... 1
3.2 Safety instructions ....................................... 2
3.3 Personal protective equipment ....................... 2
4 Installation............................................................ 2
4.1 To do before the installation of the
product...................................................... 2
4.2 To install the differential pressure
transmitters ................................................ 2
4.3 Description of the pressure transmitter .............3
4.3.1 To set the pressure range on the
pressure transmitter ......................... 3
4.3.2 To zero point calibrate the
pressure sensors............................. 3
4.3.3 To reset to factory settings ................. 3
4.3.4 Status LED light .............................. 3
5 Technical data....................................................... 4
5.1 Wiring diagrams .......................................... 4
5.2 Topvex SR/TR, SC/TC.................................. 4
5.3 Topvex FR, FC, SF ...................................... 5
6 To configure the pressure transmitter in the air
handling unit controller........................................... 5
6.1 For SR/TR, SC/TC, FC, FR............................ 5
6.1.1 To log in ........................................ 5
6.1.2 To start the configuration
wizard ...........................................6
6.1.3 To activate the pressure control
function ......................................... 6
6.1.4 To allocate differential pressure
sensors ......................................... 6
6.1.5 To adjust the fan pressure set
points............................................ 7
6.1.6 To save local settings ....................... 7
6.2 For SF units ...............................................8
6.2.1 To log in......................................... 8
6.2.2 To set the fan control type.................. 8
6.2.3 To set the adjusted working
range ............................................ 8
6.2.4 To set air control setpoint................... 8
6.2.5 To set alarm limit ............................. 9
6.2.6 To allocate in- and outputs ................. 9