BLANDOVENT IMO GB SE CE 135573 A001

_________________________________________________________________________________________________________
Blandovent Drift och skötselinstruktioner
204268
2
GB
Mounting:
Blandovent is suspended by chains 0.5 m from the
ceiling. Set the diffuser with reference to existing
objects on the floor of the premises.
Regulation:
The integrated axial fan can be speed regulated by
reducing the supply voltage. This can be done using
the five step transformer RTRE 1.5 or steplessly
using thyristors. A thermostat can also be connected
to Blandovent.
Safety:
The fan is intended for room air circulation. After
Installation it must not be possible to move the
moving parts. The fans must not be used in explosive
environments or connected to flues. The fans must
not be installed outdoors. Safety components (e.g.
touch guards) must not be removed, bypassed or
disconnected. NOTE Before carrying out servicing
and maintenance the fans must be disconnected
from power, main switch off, and the fan impeller
must have stopped. NOTE The fans may have sharp
edges and corners, which can cause cutting injuries.
Transportation and storage:
All fans supplied by Systemair are packed for normal
goods handling. During handling, use suitable lifting
equipment to prevent damage to fans and injury to
people. NOTE Do not lift the fans by the motor
cables, junction box, fan wheel or inlet cone. Avoid
any bumps and impacts. The fans must be dry stored
and weather protected from dirt and dust prior to final
installation.
Installation:
Also see the safety section. Installation, electrical
connections and commissioning must be carried out
by authorised installers in accordance with local rules
and regulations. Electrical connection must be carried
out according to the wiring diagram in the junction
box, markings on the terminal block or on cables.
NOTE Do not use metal unions if the junction box is
made of plastic. Seal any empty union holes with
blind plugs. Install the fan in the correct air direction
(see air direction arrow). The fan must be installed so
that vibrations cannot be transferred to the building
structure. The fans are usually installed vertically.
Fans with manual thermal contacts (reset by
disconnecting the power), must be taken into
consideration when connecting surrounding
equipment with automatic on/off function.