Manual IH

IH
8
EN
Maintenance
The power supply to the unit must be
disconnected during all service, repair and
maintenance work. Wait until the unit is
cold. The unit has no moving parts so the
maintenance requirement is small, but it
must be kept clean and free from dust and
dirt. If the reflector is not clean the thermal
radiation from the unit will decrease and the
heater will become hotter. A large amount
of dirt can cause overheating. The surface of
the reflector is sensitive and must be cleaned
with care. If the reflector is dirty it must be
cleaned or replaced by a specialist.
Replacing the lamp
The heat lamp is of the highest quality and
unless it is subjected to mechanical strains in
the form of vibrations and impact it will last
for a long time. The service life is dependent
on the ambient temperature and how the
heater is installed. When the heater is
installed freely and outdoors the temperature
will be low and the life of the lamp can be
expected to be in the region of 3000 hours.
The lamp must be replaced by an installer or
other skilled person.
1. Disconnect the power supply.
2. Wait until the unit is cold.
3. Remove the covers at both ends (four
screws).
4. Pull the grille to one side.
5. Remove both reflector ends (two screws).
6. Loosen the connections on the terminal
block.
7. Pull the lamp out of the lamp holders.
8. Check that the replacement lamp has the
correct output and voltage.
9. Fit the new lamp. Note do not touch the
lamp with your fingers, wear gloves or the
like.
10. The protective tube must be refitted to the
cables, so that the cables are not damaged
when the grille is fitted.
11. Reassemble the unit again.
See the introduction pages.
Packaging
Packaging materials are chosen with
consideration to the environment and are
therefore recyclable.
Handling of product at end of working life
This product may contain substances
necessary for the functionality of the
product but potentially dangerous for the
environment. The product should not be
disposed of mixed with general household
waste but delivered to a designated collection
point for environmental recycling. Please
contact the local authority for further details
of your nearest designated collection point.
Safety
• For all installations of electrically heated
products a residual current circuit breaker
300 mA for fire protection should be used.
• The unit must not be fully or partially
covered as overheating can result in a fire
risk!
• The unit must not be placed directly under
fixed wall sockets!
• The unit must not be used if the unit or the
cord is damaged. Risk of injury!
• The heater is equipped with a protective
grille to prevent contact or to prevent
large objects from touching the hot lamp.
The unit must not be used without this
protective grille.
• The cable and plug must not be placed
inside the hot radiant area.
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.