Manual K21

11
Safety
• Do not use heater in locations with a lot of dust as this may pose
a risk of a short circuit in the heating element.
• Do not use the heater in the immediate vicinity of showers,
bathtubs, or swimming pools.
• e heater must not be located directly underneath a fixed
wall socket.
• Place the heater on a stable floor.
• e heater must not be covered as this can create a fire hazard
(see picture A).
• Position the heater so that combustible materials cannot be ignited.
• Some of the external surfaces of the heater become hot during operation.
Bare parts of the body should not exposed to the hot air outlet.
• Never stick foreign objects into the heater’s air inlet or outlet.
ere is a big risk of coming in contact with live electrical parts.
• Be extra careful when there are children in the vicinity of the heater.
• If the heater is used outdoors, it must be protected against rain.
• Always pull the plug out of the wall socket when the heater is not in use.
Function
e heater fan is equipped with a heating power selector and a thermostat.
e power selector has three positions:
0 - off. 1000W - fan + half heater power. 2000W - fan + full heater power.
ermostat working range: +5°C to +40°C. e thermostat starts the fan + the selected heater
power, when heating is needed. If the temperature inside the heater fan should become too high
for any reason, the automatic temperature limiting device will be activated.
Service
Clean the outside of the heater fan at regular intervals, since accumulations of dust and dirt may
cause a fire.
Repairs
e following work should be done by the manufacturer, service company or some other equally
qualified person:
Changing the power supply cable.
Cleaning of the PTC element with compressed air. If heavily soiled, remove the upper bend.
A
GB