Manual SH

Bench heater SH
EN
8
Installation and operating instructions
Maintenance
In all electrical heating appliances, small
clicks can occur due to movement when the
material expands and contracts with changes in
temperature.
As the components are maintenance-free, no
maintenance other than cleaning is necessary.
The frequency of cleaning can vary depending
on local conditions, although it should be at
least twice a year. Grilles and elements can
be vacuum cleaned or wiped using a damp
cloth. Use a brush when vacuuming to prevent
damaging sensitive parts.
Packaging
Packaging materials are chosen with
consideration to the environment and are
therefore recyclable.
Handling of product at end of working
life
This product may contain substances necessary
for the functionality of the product but
potentially dangerous for the environment. The
product should not be disposed of mixed with
general household waste but delivered to a
designated collection point for environmental
recycling. Please contact the local authority
for further details of your nearest designated
collection point.
General Instructions
Read these instructions carefully prior to
installation and use. Keep this manual for
future reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid should the product be used
in the manner intended and in accordance with
the instructions.
Application
Bench heater SH is designed for use with
church pews, waiting room benches and the
like. The bench heater is installed under the
seat and distributes heat in the occupied zone
through convection and radiant heat.
Protection class: IP21.
Mounting
Bench heater SH is installed horizontally
underneath benches, mounting brackets are
included. The holes in the brackets are ø6 mm
with a c -c distance of 90 mm. The space under
the bench may only be completely covered on
two sides.
1. Mount the brackets underneath the bench
and then t the heater into the brackets.
2. Fix the heater to the brackets by using the
the premounted screws on the bracket. The
brackets can be mounted with a exible c-c
distance.
Note! The heater may not be angled or pointing
upwards. For minimum distance, see diagrams
on introductory pages.
Electrical installation
The installation, which should be preceded by
an isolator switch with a contact separation
of at least 3 mm, should only be wired by a
competent electrician and in accordance with
the latest edition of IEE wiring regulations.
Bench heater SH is intended for permanent
installation and is approved for parallel
connection. The connection box contains
terminal blocks, 5x4 mm² making it possible
to connect several heaters in parallel, via two
cable glands ø18 mm.
Control
When using this product as a local space
heater according to Ecodesign Regulation
(EU) 2015/1188, it must be supplemented with
one of the following approved controls. Please
note that a relaybox RB3 is required for 400V~
products.
• TAP16R, electronic thermostat that includes:
- Electronic room temperature control plus
week timer
- Room temperature control with open
window detection
- Adaptive start control
The product can be controlled in a different
way, e.g. by an overall control system (BMS),
but in that case the responsibility lies with the
installer to ensure that the control system is
programmed to make the installation meet
the requirements of Ecodesign Regulation
(EU) 2015/1188.