User's Manual

Cocking Rod Adjustment
Two things affect the bolt backward movement, the Cocking Block to Ram adjustment,
and the Cocking Rod adjustment.
To check the Ram adjustment, remove the Cocking Rod, manually pull the Cocking
Block backward until it stops, and look down the feed tube to see if the Bolt tip has
cleared the feed tube hole. If it does not clear the hole, refer to the Ram to Cocking
Block adjustment section of this manual. If the Bolt does clear the hole, the Cocking
Rod needs adjusted. Make the following adjustments.
1. Along with the standard precautions, make sure there is no CO
2
or air connected
to or in the marker. Make certain that there is no paintballs in the gun or feeder
on the marker.
2. Remove the Cocking Rod and the Cocking Rod Bumper. Unscrew the knob from
the rod. We use Loctite at the factory, so removal of the knob may be difficult.
Clean the threads on the end of the Cocking Rod so that the Cocking Knob
screws onto the Cocking Rod freely.
3. Begin by putting a drop of Loctite in the knob threads (Do not put Loctite on the
threads that go into the marker). Then screw the Cocking Knob on the Cocking
Rod, slide the bumper onto the Cocking Rod, and insert the rod into the marker.
Thread the rod into the Hammer, and then pull back on the Cocking Block until it
makes contact with the bumper. Look down the Feed Tube to see if the Bolt
clears the Hole. If it doesn’t, rotate the Cocking Knob (not the Cocking Rod) in a
counter clockwise direction until the Bolt clears the Feed Tube. Allow at least 30
minutes for the Loctite to set and dry.
4. Adjustment is now completed.
Hose Replacement
To replace the hose, follow these steps:
1. Remove the hose from the fitting. Cutting is usually required.
2. Remove any pieces of the hose left behind on the fitting.
3. Cut the new hose to length with a razor blade or wire cutter.
4. Place the hose over the fitting and push until it is fully seated.
5. Back off on the front Regulator knob a half turn before charging your marker with
CO
2
or air, then readjust the Regulator following the before mentioned
instructions.
Velocity Adjustment
To adjust the velocity of your marker, follow these instructions:
1. Remove the Cocking Rod (located at the rear of the marker).
7