User's Manual

Three-Way Valve Adjustment
Note: The three-way valve actuating rod should never need adjustment unless the rod is
removed. Never remove the rod unless there is a problem with the air receiver or the
three-way valve itself.
External Three-Way Adjustment
1. Three-way and coupler is one piece for easy adjustment.
2. To adjust your Three-way, screw the front adjusting knob clockwise until the
Three-way leaks. Screw counter clockwise 1-1/2 turns or to your desired
position.
In-Line Regulator
1. Your In-Line Regulator is preset from the factory at 300 psi.
2. To adjust your In-Line Regulator, turn the bottom adjusting knob in a clockwise
direction to lower the pressure, or in a counter clockwise direction to increase the
pressure.
Ram to Cocking Block Adjustment
1. Make sure the barrel plug is installed and the marker does not have paintball in
the barrel or a feeder on the marker.
2. Remove the bolt and the Cocking Rod from the marker. Loosen the Cocking
Block by turning the block counter clockwise on its rod.
3. Make sure you manually cock your marker. This is done by pulling back on the
back block and cocking rod.
4. Install CO
2
or air source.
5. When you pressurize the system the Ram should retract completely (pulling the
block forward). At this time there should be a gap between the Cocking Block
and the main body.
6. Rotate the Cocking Block clockwise until it touches the main body of the marker.
Continue rotating the cocking block until the large Bolthole in the Cocking Block
lines up with the Bolthole on the main body.
7. Install the Bolt and the Cocking Rod, and your adjustment is complete.
6