User's Manual

ManualsBrandsSystem Sensor ManualsHome Security SystemSystem Sensor Home Security System P2R

D690-03-00 4 I56-2769-003R

Mounting

Figure 6.

Figure 7.

Back box skirt

model numbers:

BBS-2, BBSW-2,

BBSC-2, and BBSCW-2

Mounting (Wall or Ceiling)

1. Attach mounting plate to junction box as shown in Fig-

ure 6. The mounting plate is compatible with 4˝ square,

double gang, and 4˝ octagon junction boxes (2-wire

products may be used with a single gang box). If using

a back box skirt, attach the mounting plate to the skirt

and then attach the entire assembly to the junction box

(see Figure 7).

NOTE: For outdoor applications, the product must be

installed using the proper SpectrAlert Advance water-

tight junction box. The wall mount watertight junction

box must be mounted with its internal post in the lower

left corner as shown in Figure 8.

2. Connect ﬁeld wiring according to terminal deﬁnitions.

3. If the product is not to be installed at this point, use the

dust cover to prevent contamination of the wiring termi-

nals of the mounting plate.

4. To attach product to mounting plate, hook tabs on the

product housing into the grooves on mounting plate.

Then, swing product into position to engage the pins on

the product with the terminals on the mounting plate.

Make sure that the tabs on the back of the product hous-

ing fully engage with the mounting plate.

5. Secure product by tightening the single mounting screw

in the front of the product housing.

NOTE: Standard captured mounting screw may be re-

placed with enclosed torx screw for tamper resistance.

Figure 8.

The horn and/or strobe will not work without power. The horn/strobe gets its

power from the fire/security panel monitoring the alarm system. If power is cut off

for any reason, the horn/strobe will not provide the desired audio or visual warning.

The horn may not be heard. The loudness of the horn meets (or exceeds) current

Underwriters Laboratories’ standards. However, the horn may not alert a sound

sleeper or one who has recently used drugs or has been drinking alcoholic bever

ages. The horn may not be heard if it is placed on a different floor from the person

in hazard or if placed too far away to be heard over the ambient noise such as traffic,

air conditioners, machinery or music appliances that may prevent alert persons from

hearing the alarm. The horn may not be heard by persons who are hearing impaired.

NOTE: Strobes must be powered continuously for horn operation.

The signal strobe may not be seen. The electronic visual warning signal uses an extremely

reliable xenon flash tube. It flashes at least once every second. The strobe must not be in

stalled in direct sunlight or areas of high light intensity (over 60 foot candles) where the visual

flash might be disregarded or not seen. The strobe may not be seen by the visually impaired.

The signal strobe may cause seizures. Individuals who have positive photoic response

to visual stimuli with seizures, such as persons with epilepsy, should avoid prolonged

exposure to environments in which strobe signals, including this strobe, are activated.

The signal strobe cannot operate from coded power supplies. Coded power supplies

produce interrupted power. The strobe must have an uninterrupted source of power in order

to operate correctly. System Sensor recommends that the horn and signal strobe always

be used in combination so that the risks from any of the above limitations are minimized.

WARNING

The Limitations of Horn/Strobes

Three-Year Limited Warranty

System Sensor warrants its enclosed product to be free from defects in ma-

terials and workmanship under normal use and service for a period of three

years from date of manufacture. System Sensor makes no other express war

ranty for this product. No agent, representative, dealer, or employee of the

Company has the authority to increase or alter the obligations or limitations

of this Warranty. The Company’s obligation of this Warranty shall be limited

to the replacement of any part of the product which is found to be defective

in materials or workmanship under normal use and service during the three

year period commencing with the date of manufacture. After phoning System

Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization

number, send defective units postage prepaid to: System Sensor, Returns

Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please

include a note describing the malfunction and suspected cause of failure.

The Company shall not be obligated to replace units which are found to be

defective because of damage, unreasonable use, modifications, or alterations

occurring after the date of manufacture. In no case shall the Company be

liable for any consequential or incidental damages for breach of this or any

other Warranty, expressed or implied whatsoever, even if the loss or damage

is caused by the Company’s negligence or fault. Some states do not allow the

exclusion or limitation of incidental or consequential damages, so the above

limitation or exclusion may not apply to you. This Warranty gives you specific

legal rights, and you may also have other rights which vary from state to state.

FCC Statement

SpectrAlert Strobes and Horn/Strobes have been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his own expense.

Please refer to insert for the Limitations of Fire Alarm Systems

A0348-00

A0349-00

A0354-00