Smoke Alarm User Manual

ManualsBrandsSystem Sensor ManualsSmoke AlarmBS5839

Note: This document is based on the recommendations of BS5839 Part 1: 2002. It is intended only as a guide to the application of ﬁre detection systems.

Reference must be made to relevant national and local standards.

SERIES 200 PLUS ANALOGUE ADDRESSABLE DETECTOR RANGE

INTRODUCTION

System Sensor’s Series 200 plus range of plug in smoke detectors are a family of analogue addressable smoke detectors

combining state of the art design with micro-processor control and sophisticated processing circuitry to provide fast, efﬁcient

ﬁre detection in a wide range of applications.

All Series 200 plus detectors have two integral LEDs, which provide local visual indication of the sensor status. These LEDs

provide a dual function. In the event of an alarm, they are switched ON continuously, and can also be programmed to either

blink when polled by the panel or remain off during normal conditions. In addition to their integral LEDs, Series 200 plus

detectors can be connected to a remote LED indicator.

The individual loop address of each Series 200 plus detector can be easily set and read, using the rotary decade address

switches located on the rear of each sensor. The use of decimal address codes signiﬁcantly reduces the potential for incorrect

address selection.

Each sensor base includes a tamper resistant option which, when activated, prevents the removal of the sensor from its base

without the use of a tool.

Full circuit functionality can be easily conﬁrmed on site by use of the sensor test switch. This comprises a switch operated by

a magnet near the side of the detector. Operation of this magnetic switch simulates the effect of smoke or heat on the detector,

and will generate an alarm response to the ﬁre alarm control panel, making system testing both convenient and simple.

System Sensor Intelligent Product Range

SERIES 200 PLUS FEATURES

• Microprocessor precision control

• Automatic drift compensation.

• Enhanced signal processing for improved stability.

• Extended Temperature Range

• Twin LED indicators providing 360° visibility

• Rotary Decade Address Switches

• Stable communication with high noise immunity

• Tamper-Resistant (standard feature)

• Built in test switch

• Third party certiﬁed to the latest EN54 standards with

multiple alarm thresholds

GENERAL SPECIFICATIONS

Electrical

Voltage Range: 15 to 32VDC

Standby Current: 200µA at 24VDC (No communications)

Alarm Current: 7mA at 24VDC

Environmental

Temperature Range: -20°C to 60°C

Humidity: 10% to 93% Relative Humidity

(Non-condensing)

Mechanical:

Diameter: 102mm

Maximum Wire Gauge: 2.5mm²

Colour: Pantone Warm Grey 1C

Material: Bayblend FR110