User's Manual
Table Of Contents
GlobalTrak ™ Field Setup and Diagnostic Guide
2.0 Testing Sensor Module Operation
Note: Be sure to complete 1.0 initial setup.
Test Sensor Suite functionality
2.1 Configure the installation as follows.
Door (If Applicable): Open
Mount (If Applicable): Unmounted
External Power (If Applicable): Disconnected
2.2 Switch the CMU to the On (Horizontal) position.
2.3 Allow the CMU to run through one complete boot cycle and switch the AMU to the Off
position. Completion is indicated by the screenshot shown in Figure 2.1.
Figure 2.1
Prepared: R. Straz Date: May 31, 2006 Page 6 of 17