User's Manual

GlobalTrak ™ Field Setup and Diagnostic Guide
1.0 Initial Setup
Connect the CMU to HyperTerminal
1.1. Disconnect the fielded CMU Cable circular connector (if any) and connect the field test
cable as shown in figure 1.1.
INSERT FIGURE HERE
Figure 1.1
1.2. Open a HyperTerminal on the computer.
1.3. Name the connection by the following convention and press ‘OK’.
XXXX_MM-DD-YY
XXXX = Last four digits of the CMU serial number
MM = two digit month
DD = two digit day
YY = two digit year
1.4. Select the COM port number that the CMU is connected to and press ‘OK’.
1.5. Set the COM port properties using the settings shown in Figure 1.2 and press ‘OK’.
Figure 1.2
Prepared: R. Straz Date: May 31, 2006 Page 4 of 17