User's Manual

V3d Product Specification, Version 2.06
5.5 Power I/O Cable Assembly
A cable assembly enables access to the Power I/O connector. Each battery charging lead is
color coded 20 AWG and is terminated into a keyed shrouded power connector, accompanied
by a ground wire. Similar for the external power lead. The main serial leads are color coded 24
AWG and are terminated into a 9-pin D-sub connector to enable simple connection to a PC.
The digital and analog I/O leads are color coded 24 AWG and are left unterminated. Heavy
duty black plastic sheathing covers the wires. Heat shrink mates the sheathing to the connector
backshell. The assembly is 1 meter in length.
5.6 Component Serial Designations
The battery, antenna and enclosure are to be marked with a unique serial number, bar code
scannable.
5.7 Antenna Cable
Any antennas provided with the V3d shall be equipped with an antenna cable length of 2m with
a heat shrink sheath over the cables. Approximately 15cm at the end of the cable shall be left
unsheathed to allow for connection to V3d.
MobiApps Proprietary & Confidential Document
© 2006 Page 21