User's Manual

V3d Product Specification, Version 2.06
• Lithium Thionyl Chloride, assembled from three 3.6V cells providing a nominal voltage of
10.8V. This is primary battery which cannot be recharged.
• Lithium Ion, assembled from three 3.6V cells providing a nominal voltage of 10.8V. This
is a rechargeable battery; however charging is possible over a limited temperature range
compared to discharging.
• Sealed Lead Acid, assembled from five 2V cells, providing a nominal voltage of 10V.
This is a rechargeable battery.
3.7.2 Power Alternatives
To enable alternative power methods, the V3d shall accept power from an external source
connected to the external power lead, but only under the condition that the V3d internal battery
is physically removed from the enclosure. The external power source must be a battery or
similar, such as a bench power supply. No ripple or noise can be present on the external power
lead, other than what is normally produced by the chemical reaction within a battery. Allowable
voltage range is 9 to 16 VDC.
Note: External power is allowed and expected on the SLA Charging Power or Li-ion Charging
Power pins. The restriction stated here applies only to the External Power pin.
3.7.3 Sleep Current
The V3d is expected to support a wide range of applications, including some where sleep
periods extend to 24 hours or more. Therefore the power consumption while in sleep mode is
very important, and is limited to TBD uA @ 12 VDC (TBD mW).
MobiApps Proprietary & Confidential Document
© 2006 Page 16
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.