User's Manual

GlobalTrak ™ GT Lite Operation and Maintenance Manual
Figure XXXXXXXXX
7. Power on the GT Lite
8. Stop the application by typing the following command in HyperTerminal:
AT+WOPEN=0 <enter>
9. Start the bootloader by typing the following command in HyperTerminal
AT+WDWL <enter>
10. If the processor is in booloader mode, GT Lite should be printing a special character to the
screen as shown in Figure XXXXX below.
Figure XXXXXXXXX
11. Send the code by selecting Transfer Æ Send File…
12. Select the desired binary code file (.wpb.dwl) and use the following settings:
Prepared: R. Straz Date: July 25, 2007 Page 45 of
139