User's Manual
Table Of Contents
GlobalTrak™Assembly203026,E‐SealwithZigBeeInterfaceV2OperationManual
Prepared: J. Carn Date: May 24, 2012 Page 11 of 11
PerFCC 15.21:Changesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecould
voidtheuser’sauthoritytooperatetheequipment.
PerFCC15.105
:NOTE:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigital
device,pursuanttopart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainst
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not in‐stalled and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particularinstallation.Ifth isequipmentdoescauseharmfulinterferencetoradioortelevisionreception,which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interferencebyoneormoreofthefollowingmeasures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
PerFCC2.1093
:ThisequipmentcomplieswiththeFCCRFradiationexposurelimitssetforthforanuncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20 centimeters
betweentheradiatorandyourbody.
ForIndustryCanada
:
ThisdevicecomplieswithIndustryCanadalicence‐exemptRSSstandard(s).Operationissubjecttothefollowing
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
includinginterferencethatmaycauseundesiredoperationofthedevice.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectriqu e subi, même si le
brouillageestsusceptibled'encompromettrelefonctionnement.