Data Sheet

RM9000
Multiprotocol 2.4GHz Wireless Module
Datasheet
12 / 17
System Design Co., Ltd.
Selectivity, Image frequency ±1
MHz
(1)
Note that Image frequency + 1 MHz is the Co-
channel –1 MHz. Wanted signal at –72 dBm,
modulated interferer at ±1 MHz from image
frequency, BER = 10
–3
4 / 46
(2)
dB
1 Mbps (LE 1M)
Receiver sensitivity
Differential mode. BER = 10
–3
–97
dBm
Receiver saturation
Differential mode. BER = 10
–3
> 5
dBm
Frequency error tolerance
Difference between the incoming carrier
frequency and the internally generated carrier
frequency
> (–350 / 350)
kHz
Data rate error tolerance
Difference between incoming data rate and the
internally generated data rate (37-byte packets)
> ( –750 / 750)
ppm
Co-channel rejection
(1)
Wanted signal at –67 dBm, modulated interferer in
channel, BER = 10
–3
–6
dB
Selectivity, ±1 MHz
(1)
Wanted signal at –67 dBm, modulated interferer at
±1 MHz, BER = 10
–3
7 / 4
(2)
dB
Selectivity, ±2 MHz
(1)
Wanted signal at –67 dBm, modulated interferer at
±2 MHz,BER = 10
–3
40 / 33
(2)
dB
Selectivity, ±3 MHz
(1)
Wanted signal at –67 dBm, modulated interferer at
±3 MHz, BER = 10
–3
36 / 41
(2)
dB
Selectivity, ±4 MHz
(1)
Wanted signal at –67 dBm, modulated interferer at
±4 MHz, BER = 10
–3
36 / 45
(2)
dB
Selectivity, ±5 MHz or more
(1)
Wanted signal at –67 dBm, modulated interferer at
≥ ±5 MHz, BER = 10
–3
40
dB
Selectivity, image frequency
(1)
Wanted signal at –67 dBm, modulated interferer at
image frequency, BER = 10
–3
33
dB
Selectivity, image frequency
±1 MHz
(1)
Note that Image frequency + 1 MHz is the Co-
channel –1 MHz. Wanted signal at –67 dBm,
modulated interferer at ±1 MHz from image
frequency, BER = 10
–3
4 / 41
(2)
dB
Out-of-band blocking
(3)
30 MHz to 2000 MHz
–10
dBm
Out-of-band blocking
2003 MHz to 2399 MHz
–18
dBm
Out-of-band blocking
2484 MHz to 2997 MHz
–12
dBm
Out-of-band blocking
3000 MHz to 12.75 GHz
–2
dBm
Intermodulation
Wanted signal at 2402 MHz, –64 dBm. Two
interferers at 2405 and 2408 MHz respectively, at
the given power level
–42
dBm
Spurious emissions,
30 to 1000 MHz
(4)
Measurement in a 50-Ω single-ended load.
< –59
dBm
Spurious emissions,
1 to 12.75 GHz
(4)
Measurement in a 50-Ω single-ended load.
< –47
dBm
Measured on the CC1352PEM-XD7793-XD24-PA24 reference design with T
c
= 25 °C, V
DDS
= 3.0 V, f
RF
= 2440 MHz with
DC/DC enabled and high power PA connected to V
DDS
unless otherwise noted.
All measurements are performed at the antenna input with a combined RX and TX path, except for high power PA which is
measured at a dedicated antenna connection. All measurements are performed conducted.
PARAMETER
TEST CONDITIONS
MIN TYP MAX
UNIT
RSSI dynamic range
70
dB
RSSI accuracy
±4
dB
2 Mbps (LE 2M)
Receiver sensitivity
Differential mode. Measured at SMA connector,
BER = 10
–3
–92
dBm
Receiver saturation
Differential mode. Measured at SMA connector,
BER = 10
–3
> 5
dBm
Frequency error tolerance
Difference between the incoming carrier
frequency and the internally generated carrier
frequency
> (–500 / 500)
kHz
Data rate error tolerance
Difference between incoming data rate and the
internally generated data rate (37-byte packets)
> (–700 / 750)
ppm