SysOnChip SOC LBS LOOK’ET User Manual LOOK’ET LBS User Manual 2007. 10. 11. Sysonchip, Inc.
SysOnChip SOC LBS LOOK’ET User Manual Contents 1. Overview .................................................................................................................................................................... 6 1.1. Reference.................................................................................................................................................. 6 1.2. Hardware overview ...................................................................................................
SysOnChip SOC LBS LOOK’ET User Manual Table Contents Table 1. Vehicle interface pin description table........................................................................................... 10 Table 2. LED indications ............................................................................................................................. 11 Table 3. GSM/GPRS module specification ................................................................................................. 24 Table 4.
SysOnChip SOC LBS LOOK’ET User Manual Figure Contents Fig 1. LOOK’ET hardware block diagram..................................................................................................... 7 Fig 2. LOOK’ET appearance in front view .................................................................................................... 7 Fig 3. LOOK’ET appearance in right side view............................................................................................. 8 Fig 4.
SysOnChip SOC LBS LOOK’ET User Manual Cautions Information provided by SYSONCHIP is accurate and reliable. However, no responsibility is assumed for its use. Please, read carefully the safety precautions. If you have any technical questions regarding this document or the product described in it, please contact your vendor or SYSONCHIP. Trademarks Some mentioned products are registered trademarks of their respective companies.
SysOnChip SOC LBS LOOK’ET User Manual 1. Overview This manual describes the SOC LBS Real-time GPS tracker for using in the fleet management and other location utility. We calls the SOC LBS Real-time GPS tracker as “LOOK’ET”, our product name in this document from now on. Chapter 1 describes the LOOK’ET hardware part and 2,3 describe security and safety. Chapter 4 describes the stating and testing method. Chapter 5 describes the specification of LOOK’ET. 1.1.
SysOnChip SOC LBS LOOK’ET User Manual 1.2. Hardware overview LOOK’ET has following hardware block diagram. Fig 1. LOOK’ET hardware block diagram LOOK’ET has following hardware appearance. Fig 2.
SysOnChip SOC LBS LOOK’ET User Manual Fig 3. LOOK’ET appearance in right side view Fig 4. LOOK’ET appearance in left side view Fig 5. .
SysOnChip SOC LBS LOOK’ET User Manual 1.3. Hardware interface description 1.3.1. Vehicle interface LOOK’ET has 12 port signals to interface with vehicle. 1.3.1.1. Vehicle 12 pin interface pin out Fig 6. Vehicle 12 pin connector cable part Fig 7. Vehicle 12 pin connector LOOK’ET part 1.3.1.2.
SysOnChip SOC LBS LOOK’ET User Manual 12 GND operate properly; A direct connection to the vehicle’s battery is preferable. The 2A fuse in this cable is to protect the +12/24 volt input to the unit. Wire to vehicle ground. Black Table 1. Vehicle interface pin description table 1.3.2. USB interface LOOK’ET supports USB 2.0 and mini-USB type connector. 1.3.3. RS232 interface LOOK’ET supports RS232 to interface with external device like navigation.. Supported signal is RS232Tx,RS232Rx and GND.
SysOnChip SOC LBS LOOK’ET User Manual 1.3.6. LEDs LOOK’ET has three LEDs for indicating operation status. LED name Battery LED GPS LED GSM/GPRS LED Mark Description It indicates the battery status. In boot stage after power on, it blinks 4 times with 1 second period indicating boot completion. If the boot stage has some error, it blinks forever. After boot stage, It blinks if the battery voltage level is under 3.6V else on. It indicates the GPS sync status.
SysOnChip SOC LBS LOOK’ET User Manual 1.4 LOOK’ET basic operation scheme LOOK’ET has several stages to debug status and operate in test mode. User does not have to control this, but it is good to know to when the debugging command is valid. 1) Boot stage After power on, Boot stage takes 25 seconds to check the flash memory status and user program updating request. If the user want to upgrade LOOK’ET with the new binary file, it can be done in this time.
SysOnChip SOC LBS LOOK’ET User Manual 2. Security It is important for the efficient and safe operation to read this information before use LOOK’ET. This chapter contains important information for the safe and reliable use of the LOOK’ET. Please read this chapter carefully before starting to use LOOK’ET. (1) Risk of explosion if battery is replaced by incorrect type. dispose of used batteries according to the instructions.
SysOnChip SOC LBS LOOK’ET User Manual 4. Basic startup and testing The SOC LBS LOOK’ET has been made to make installation, testing and configuration simple. For vehicle installation and testing for correct working after installation we recommend the installer to use a Notebook or Desktop PC via USB 2.0 interface. The program for debugging/controlling LOOK’ET is provided in view of both target side and network side.
SysOnChip SOC LBS LOOK’ET User Manual 4.1.1. Hardware accessories 1) LOOK’ET body Fig 9. Hardware Accessory : Body 2) External GPS antenna Fig 10. Hardware Accessory : External GPS antenna 3) External GSM/GPRS antenna Fig 11.
SysOnChip SOC LBS LOOK’ET User Manual 4) 12 Pin Vehicle interface connector & cable Fig 12. Hardware Accessory : vehicle 12 pin connector & cable 5) Internal battery Fig 13. Hardware Accessory : Internal battery 6) USB mini-type connector & cable Fig 14.
SysOnChip SOC LBS LOOK’ET User Manual 7) RS232 connector & cable None. Not needed. 8) Tray for Fix LOOK’ET Fig 15.
SysOnChip SOC LBS LOOK’ET User Manual 4.1.2. Software programs 1) USB Driver install file USB driver installation is needed to connect the LOOK’ET with PC. After completed installing the USB driver, hyper terminal and DM can be used to control and debug the LOOK’ET. Refer to the document [1] and [3] for detail description to install USB driver and DM. 2) DM(Diagnostic Monitor) Program LBS_DM.exe, configuration text file and several DLL files are provided by SOC.
SysOnChip SOC LBS LOOK’ET User Manual 4.2. Testing environment & Installation 4.2.1. Testing environment The testing environment of LOOK’ET is as followings. Basic period report message, which is occurred by period during ignition on or off, is reported to the control center. History report & logging message can be checked at DM and control center at any time during GPRS connection is established. Also daily history report can be sent E-mail server or other GPRS server by configuration setting.
SysOnChip SOC LBS LOOK’ET User Manual 4.2.2. Installation & Usage 4.2.2.1. Component connection (1) Connect the external GSM antenna and external GPS antenna (2) Connect the USB connector LOOK’ET and PC. (3) Connect the 12 pin vehicle interface connector LOOK’ET and Vehicle. The VIN,GND and IGNITION signals of vehicle interface must be connected to the vehicle. If this signals are not connected with vehicle, use power supply or 12V/24V battery.
SysOnChip SOC LBS LOOK’ET User Manual (4) Open the rear cover and insert the SIM card. (5) Insert the Internal battery. Inserting internal battery means the power On. (6) You can execute “CONNECT” in the DM program. You can see the processing status. (7) After about 25 seconds, Boot process is completed, LEDs for GSM and Power will be blinked 4 times. Then LOOK’ET will process the application code. Application code will initialize its configuration and goes to the idle state.
SysOnChip SOC LBS LOOK’ET User Manual 4.2.2.2. USB driver installation & test Refer to the document [1] for detail description. 4.2.2.3. DM installation Refer to the document [1] for detail description. 4.2.2.4. Configuration setting by DM Refer to the document [3] for detail description. 4.2.2.5. Confirm the connection with control center Refer to the document [2] for detail description. 4.2.2.6. Program updating Program updating using DM is described in the document [3].
SysOnChip SOC LBS LOOK’ET User Manual 5. Specification 5.1. Software features z SMS mode/GPRS mode/SMS+GPRS mode z Position request via SMS or GPRS z Auto position logging or reports, based on configurable time or distance interval z Data logging capacity : up to Max. 1,440 point z Upload/download settings, locations, and update firmware via GPRS.
SysOnChip SOC LBS LOOK’ET User Manual z Antenna Default GPS patch antenna External GSM/GPRS antenna Optional external boost GPS antenna z Indication 3 LED’s for GSM/GPRS and GPS status z Certificate Compliant with the EU RoHS Directive CE, FCC, E-mark 5.3.
SysOnChip SOC LBS LOOK’ET User Manual Table 4.
SysOnChip SOC LBS LOOK’ET User Manual 6. History Document history V 0.9 V 0.91 Sep.28, 2007 star4u Oct.11, 2007 star4u Document creation. Added chapter 2(Security) description Added chapter 3(Safety standards) description Added vehicle interface pin out.
