User's Manual

SYSON BLUETOOTH GPS User Manual v.1.0
CONTENT
01
Designation
02
[SOC2S03] SYSON BLUETOOTH GPS
CONTENT
1. Product Designation
2. Getting Started
3. PDA Connection Guide
3.1. Connection with Fujitsu Siemens Pocket LOOX 600
3.2. Connection with with HP iPAQ Series
4. Users' Tips
5. Unit Package
6. Optional Accessory
Note
Thank you for purchasing SysOn
TM
Blueooth GPS receiver.
SysOn
TM
Blueooth GPS is a wireless GPS receiver which turns
a Bluetooth-enabled PDA or computing device to a wireless navi -
gation system.
Please carefully read this user guide instruction before using
the product.
Disclaimer and limitation of liability
Sysonchip, Inc. and its affiliated companies assume no respon -
sibility for any damages and loss resulting from the use of this
manual and also by deletion of data as a result of malfunction,
dead battery, or misuse of the product in any way.
Warning
Any kind of changes or modification of the product that are
not officially approved by Sysonchip will void the owner's war -
ranty and also any other obligation of Sysonhip to repair or
replace the product.
Information and instruction in the manual is subject to
change without notice at any time.
Online Product Registration
http://www.sysonchip.co.kr/eng/supp/sup_reg.htm
1. Designation
1. Battery Status LED (red/green)
2. GPS status LED (orange)
3. Bluetooth status LED (blue)
4. Optional external antenna connector port
5. Power jack
6. Power switch
5
4
1
2
3
6
NO
1
2
3
4
5
6
LED
Battery Status LED
GPS Status LED
Bluetooth Status LED
Optional external antenna
connector port
Power Jack
Power Switch
RED
GREEN
ORANGE
BLUE
Function
ON : During charging battery with connection
to a power charger
OFF : Once bettery is fully charged
ON : Low Battery Indication. Charge battery
immediately.
OFF : Normal status. Battery has adequate
power suply.
BLINKING : Position is fixed on the reception
of GPS signal (1 PPS Output)
BLINKING : No Bluetooth connection yet.
Finding Bluetooth connection.
ON : Bluetooth connection is on and ready for
data transmission
You may use an external antenna optionally
instead of a built-in internal antenna. Simply
plug the external antenna into the port.
Connect a power charger to the power jack to
recharge the internal battery
Power on/off switch