User's Manual

Bluetooth Software Suite Users Manual
73
Diagnostics
After the installation, it is recommendable to check
that the hardware for the Bluetooth Software Suite
has been installed properly. This is done by
performing a
loopback test
. This test is carried out
from the Bluetooth Configuration Tool:
1. Open the Microsoft Control panel.
2. Double-click Bluetooth Configuration Tool.
The Bluetooth Configuration Tool dialog box
opens:
3. Click the tab Diagnostics. This will open the
window where you can perform a loopback
test to check if your hardware is working
properly:
4. In Loop Mode, select either Single Loop (to
test a single loop) or Infinite Loops (to test a
number of loops). We recommend that you
choose the latter (which is also the default
setting).
5. To start the test, click Run. When in the loop
mode Infinite Loops, the test will run until you
click Stop.
6. In Loop Count you can see the number of
loops tested. The number of Errors should
always be: 0. If the test shows one or more
errors, your hardware has probably not been
installed correctly. We recommend that you
• Make sure that the hardware is installed
correctly (cf. the Installation Manual).
• Restart your computer.