® baton SYR WV0S713 7" Digital Wireless Observation System sunniness Pi Sight” technology WVO0S713 Features: High Performance Automotive Grade 7" Color LCD Pansy 3 Camera Input (| Wireless Input Camera} OPALESCENT Compatible DC Auto Source Switching Triggers (Turn signal compatible) Backbit Control Buttons Built-in Audio Speaker Manual/auto Day/night Display Brightness Modes Programmable Source Name OSD Camera-Monitor Warnings! 1.
WVOs713 Important! Please Read This Manual Before Installing! Congratulations on your purchase of a Voyager WVOS713 LCD Observation Monitor. with WISIght™ technology. With proper Installation and use, your WOS713 Is designed to provide you with years of trouble-free operate the unit. Please read this manual thoroughly beginning. All Voyager Observational products are strictly Intended to be Installed as supplement ald to standard rear-view mirror systems that may already exist In your vehicle.
WVOS713 CONTROLS AND OPERATION 1. POWER ON/OFF 2.MENU 1 23458678 Press once tums unit on Press again ums unit off -When power applied and unit Is off, only the red power button Is backbit. When unit ls muted on, all buttons are tailback. -Each one press less than 1 second enters brightness, contrast, color MENU or tint adjust mode in tums (see Fig. 1) BRIGHTNESS BRIGHTNESS. Donnybrook CONTRAST CONTRAST Donnybrook De -Time out of OSD menu is approx.
COLOR Prestigious COLOR COLOR TINT — 14 PRESS TO ADJUST TINT TINT Flag Brightness, contrast, color and tint control {See Fig.2) fm Press menu button over 2 seconds enters setup menu Press again before ime out exits menu mode — 14 PRESS TO NAVIGATE UP/DOWN CAMERAMAN i TTY DANGED 4 PRESS TO SET UP EACH MENU PRE! EXIT SETUP MEN! Flag Setup Menu = 55 TO SETUP u SELECT 1. NORMAL / MIRROR PRESS TO NAVIGATE UP/DOWN THROUGH MENU OPTIONS.
OS! 3 SELECT 2 TRIGGER DELAY TRIGGER DELAY TRIGGER 1 TRIGGER?! TRIGGER 2 {0 SEC TOOT SEC] SELECT 3.CAMERA NAME CAMERAMAN CAM « PRESS TO NAVIGATE UP/DOWN THROUGH MENU OPTIONS PRESS TO TOGGLE THROUGH NUMBER SET PRESS TO GO BACK TO SETUP MENU PRESS TO NAVIGATE UP/DOWN THROUGH MENU OPTIONS.
SELECT SCALELESS SELECT 5.
3. SELECT > 5. Day/Night 6. Volume =~ VOLUME Primary Function Input Source Select -Pressing "SELECT" button sequences source Input modes from Ch1 to Ch2 to Ch3. -Source ID Is Indicated by OSD In top left comer.
WVOSs713 INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLATION: Before drilling be sure that no cable or wiring is on the other side. Clamp all wires securely to reduce the possibility of them being damaged during installation and use. Keep all cables away from hot or moving parts, and electrically noisy components.
13 PRODUCT SPECIFICATIONS LCD PANEL SPECIFICATIONS Size/Type 7* {Analog) TFTLCD Brightness 500 CD’ Contrast Ratio 300 View Angles Top 40° Bottom 80° Horizontal t 80° Rise: 15ms Response Time Fall : 20 ms Back Light Gyps LED Back Light Life 20,000 Hours (min) = Operation Temperature Range : -20°C ~ +65°C » Storage Temperature Range: 35°C ~ +85.
S713 Paris Process If your monitor Is not receiving a signal from the camera; the two may not be paired correctly. 1. Camera and monitor must be connected to 12 Volt DC power supply. 2. Remove “pair” button cover from the side of the camera (using a coin or fiat head screwdriver). Figure 4 3. Press and hold the “pair” button on the back of the monitor for 3 seconds. and release.
