TT01 Quick Start Guide V0.0.
Power on Press 3 seconds Beep Power off In the powered mode, the power button presses for three seconds, the LCD screen is active, and a beep is heard to indicate that Press 3 seconds tool is turned off. If TT01 is idle for 10 minutes, it will automatically shut down. If the battery level is too low, you will hear three short beeps and then the tool will automatically shut down after 10 seconds.
Change the pressure unit Change sequence: PSI Idling Press 3 seconds Press 3 seconds KPA BAR
Wake-up TPMS Click Standby or pressure screen Constant beeps 2 Beeps Enter wake-up process: To cancel, click trigger button again. Wake-up successful: Interactive display the tire pressure and ID. Click Click the function button again to cancel interactive display and change to manual switching. Wake-up is unsuccessful and tool sends long beep if TT01 can’t receive any data in 20 seconds.
Battery charging Plug Mirco USB into the USB charging port, the battery icon is flashing until the battery is full and the battery icon stops flashing. USB charging Port TT01 will start up if Mocro USB plugs into charging port. In the battery charging mode, the TT01 will be canceled automatically shut down until Flashes the Mirco USB is unplugged.
FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 0.
