User's Manual

ManualsBrandsSysgration ManualsElectronicsBLE Mesh Module

SYSGRATION / Avi-on Confidential & Proprietary

2015-09-03

Product Features

 CSR 1012 Single Chip solution:

luetooth Specification 4.1 compliant

128KB memory: 64KB RAM and 64KB ROM

 RF Features:

Transmitter Power: ≧0 dBm

Receiver sensitivity: -85 dBm Typ

 External EEPROM memory provides storage for the Bluetooth software parameter and

application parameter

 Electrical:

C Supply: 1.8V ~3.6V

Low current consumption: 16 mA @3V (Peak Current)

 Small size: 18mm × 12mm ×2.3mm (L x W x H)

Summary of content (8 pages)

PAGE 1
Product Features CSR 1012 Single Chip solution: Bluetooth Specification 4.1 compliant 128KB memory: 64KB RAM and 64KB ROM RF Features: Transmitter Power: ≧0 dBm Receiver sensitivity: -85 dBm Typ External EEPROM memory provides storage for the Bluetooth software parameter and application parameter Electrical: DC Supply: 1.8V ~3.6V Low current consumption: 16 mA @3V (Peak Current) Small size: 18mm × 12mm ×2.
PAGE 2
.6 Mechanical Requirements Item Feature 2.6.1 2.6.2 PCB Weight Detailed Description 12 mm * 18 mm * 0.
PAGE 3
Bottom View: SYSGRATION /Avi-on Confidential & Proprietary 5 2015-09-03
PAGE 4
2.
PAGE 5
Pin Assignment Description: Pins Name J1 WAKE J2 J3 J4 XTAL_32K_IN XTAL_32K_OUT I2C_SCL J5 J6 VBATT I2C_SDA J7 SPI_PION J8 J9 J10 J11 J12 J13 J14 J15 J16 J17 J18 J19 J20 J21 J22 J23 J24 J25 J26 PIO[11] PIO[10] PIO[9] SPI_MISO SPI_MOSI SPI_CSB SPI_CLK PIO[4] VDD_PADS PIO[3] UART0_RX UART0_TX AIO[0] AIO[1] AIO[2] GND GND GND GND Function Description I Input to wake CSR1012 from hibernate or dormant. Default is pull-down. Analog in 32.768KHz installed, Disconnect all to this Pin. Analog In 32.
PAGE 6
Recommended of PCB Layout Pads SYSGRATION / Avi-on Confidential & Proprietary 5 2015-09-03
PAGE 7
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 8
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or colocation with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for reevaluating the end product (including the transmitter) and obtaining a separate FCC authorization.