User's Manual

STEP1:Looseningthetire
Removethevalvecapandcoreanddeflatethetire.Usethe
beadloosenertounseatthetirebead.

STEP2:Dismountthetirefromthewheel



STEP3:Dismounttheoriginalsensor
Withascrewdriverremovethefasteningscrewandsensor
fromthevalvestem.Thenloosenthenutandremovethe
valve.

STEP5Mountingthetire
Clampthe rimonto theassemblymachinesothatthevalve
facestheassemblyheadatanangleof180°





FCCNOTICE:
ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:
(1)Thisdevicemaynotcauseharmfulinterference,and(2)Thisdevicemustacceptanyinterferencereceived,including
interferencethatmaycauseundesiredoperation.

ICNOTICE:
UnderIndustryCanadaregulations,this radiotransmitter mayonly operateusingan antennaof atype
and maximum (or lesser) gain approved for the transmitter by Industry Canada.To reduce potential
radiointerferencetootheruser,theantennatypeanditsgainshouldbesochosenthatthe equivalent
isotropicallyradiatedpower(e.i.r.p.)isnotmorethanthatnecessaryforsuccessfulcommunications.