User Manual

- Press the “start button” -> The display will now change to G_5
- Bring the 7GS 5
th
gear
- Press the “start button” -> The display will now change to G_6
- Enter 6
th
gear
- Press the “start button” -> The display will not change anymore
Calibration is completed
Coupling
After a firmware update or if you exchange a component it might be required to
bind the wheel and the pedals to the dongle
The LEDs on the dongle indicate if the wheel is coupled correctly.
White LED is on: wheel is connected
Red LED is on: pedals are connected
Please note that the pedals LED is also not blinking if the batteries are empty. In this
case, just replace the batteries. Coupling is not required.
Coupling the wheel:
- Press “dongle button” -> Both dongle LEDs start blinking
- Press “base button” + “Start button” at the same time
- Wait for a few seconds until the white LED stops blinking and lights up.
Coupling the pedals:
- Press the “dongle button”-> Both dongle LEDs are blinking
- Press all three pedals (gas, brake, clutch) fully at the same time
- Wait a few seconds until the blue LED stops blinking and lights up
Please note that if it happens during gameplay that you press all 3 pedals at the
same time, it will not cause a new coupling.