User Manual

Description of Buttons
[wireframe picture of wheel, base, 2GS, 7GS, pedals with description of button
layouts for PC and Playstation. Make sure that we don’t forget to describe:
Steel tube fixation screws
Shifter buttons behind wheel
Base button
Battery case for pedals
Table clamp fixation screw
Quick release clamps
Dongle button
Dongle red and white LED]
Installation
Installation of gear sticks
[picture of tube fixation screw and tubes which are outside the base]
1. Make sure that the tube fixation screws are lose. Use a coin and not a
screwdriver
2. Insert the metal tubes into the base from the left or right side. The tube has to
be fully inserted until it comes out of the base on the other side [show picture
of a complete installed base with tubes but without gear stick
3. Tighten the tube fixation screws with a coin
4. Choose either the sequential or h-pattern gear stick and attach it to the tubes.
Put the wheel on the side to build up some counterforce and press the gear
stick on the tubes from above [picture of wheel on the side and how to install
the gear stick
5. Connect the gear stick connection cable with the base and the gear stick
[picture of installed cable]
Please note that only one gear stick can be active at the same time. The plug
on the opposite side can be used for the power supply for the pedals.