User Manual

Upgrading the Firmware
[We need to ask Heitec how this works]
Cleaning your racing wheel
Clean only with a dry or slightly damp cloth. Using cleaning solutions may damage
your racing wheel.
Troubleshooting
The Porsche 911 Turbo S wheel must not be opened or modified. Endor AG expressly
prohibits analysis and utilisation of the electronics, hardware, software and firmware
contained in the controller.
In case difficulties occur in connection with utilisation of the Porsche 911 Turbo S
wheel, please use the following guide for eliminationof errors.
On the website www.Fanatec.com you will find further details and contact data.
Clutch or H-pattern Gear shift is not working at all
1. Please make sure that your game supports this feature.
2. Please Check if you have chosen the right settings in the options menu of the
game
3. Please make sure that the gear stick cable is connected properly
4. Please make sure that the gear stick is calibrated
Pedals are not working properly
1. Make sure that there is power supply for the pedals either with batteries or the
power supply cable for the pedals
2. Make sure that the pedals are coupled correctly (see further instructions in the
section “coupling”
3. Interference from other RF devices. Please turn off other RF devices until the
problem is solved.
Wheel is not working properly
1. Please check if the game is supporting the wheel and if you selected the right
settings in the options menu of the game.
2. Make sure the latest version of the Porsche wheel driver is installed (PC only)
3. Please make sure that the power cable is connected properly. After the wheel
is connected it should automatically self calibrate
4. Please check if there is a connection between the dongle and the wheel. The
white LED on the dongle must shine permanently. In case it does not, try to
couple it (further info in the section “Coupling”)
Force Feedback strength gets weaker
Under certain circumstances like it can happen that the Force feedback Motor of
the wheel might be in danger to overheat. The built in temperature sensor will
automatically reduce the power of the Force Feedback effects until the normal
operating temperature is reached.
Problems with driver
Please make sure to download the latest version of the driver at www.Fanatec.com