Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply vita the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 2nd, if not installed and used in accordance vita the instructions, xay cause harmful interference to radio communications.
MINUTEMAN UNINTERRUPTIBLE POWER SUPPLIES MBK Series User's Manual 1. Introduction 2. Controls and Indicators . 3. Installation ‘ 4. Operation . 5. Troubleshooting 6. Replacing the Battery 7. Obtaining Service 8. Specifications 9. Configurable Parameters & Settings 10. Limited Product Warranty PRODUCTION Thank you for purchasing a Minuteman power protection product, It has been designed and manufactured to provide many years of trouble free service IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS ! .
WARNING: Changes or modifications to this unit not expressly approved by the AN party responsible for compliance could void the user's authority to operate the equipment : . Receiving Inspection After removing your Minuteman UPS from its carton, it should be inspected for damage that may have occurred in shipping. Immediately notify the carrier and place of purchase if any damage is found.
MBK Series Uninterruptible Power Supply Users Manual AEN ros AND INDICATORS FRONT PANEL online \ EQ on-battery = Frost panel Press ang release the on/offftest button after one beep to tum the anti on of off (see section 4) reign interlace Port (MBK S20 4,880 ory) no Ox SAF Boe] = Neal Circuit Broader ® EE Rear panel REAR PANEL {120 vac models shown) The modular connectors are.
| Aaron INSTALLATION PLACEMENT Install the UPS in a temperature con trotted environment that is Irene of conductive contaminants. Select a location which will provide good air circulation for the LIPS at aif times. Avoid locations near heating devices, war or excessive tumidity, or where the UPS 18 exposed to direct sunlight. Route power cords so they Cannot be walked on or damaged CONNECTING TO AN AC SOURCE Plug the UPS into a two pole, three wire, grounded receptacle only.
AAT, 03. 0 eis rin aon po EA | TURNING THE UNIT ON/OFF ee On / Off J Test Switch Press and release the switch after one beep to tum the unit on and supply power to the load.
USER NOTES SWITCH Battery Backup Rear Panel Switch Functions During normal AC operation the rear panel 8 ® switch may be used to charge the low voltage || LA | transfer level.
I wm TROUBLESHOOTING TROUBLESHOOTING CHART i rise OE, Symptom Possible Cause ‘What To Do UPS will not turn on pushed On / Off / Tet button not Press On bunion momentarily, (one beep) to start UPS UPS operates in battery made only even though there is normal AC present Input AC breaker is tripped Reset circuit breaker by pressing the plunger back in.
ra I cine THE BATTERY REPLACING THE BATTERY : . The MBK Series UPS has an easy to replace hot-trappable battery, Please read the following warning statements before attempting to service the battery. WARNING Gls UNINTERRUPTIBLE POWER SOURCE CONTAINS POTENTIALLY HAZARDOUS VOLTAGES. TEMPTATION TO DISASSEMBLE THE UNIT BEYOND BATTERY REPLACEMENT PROCEDURES BELOW. EXCEPT FORTH BATTERY, THIS UPS CONTAINS NO USER SERVICEABLE PARTS.
RANTS nine SERVICE Co 7\/ IF THE UPS REQUIRES SERVICE —— ee ER SERVICE 1.Use the TROUBLESHOOTING section § to eliminate obvious causes 2 Verify that no circuit breakers are tripped. A tripped circuit breaker is the most conman problem 3 Call your dealer for assistance. If you cannot reach your dealer, of if he cannot resolve the problem. call or FAX. Minuteman Technical Support at the following numbers; Voice phone (972) 446-7363, FAX line (972) 446-9011.
ANE: curse PARAMETERS EN /B SETTINGS (These items require optional software or hardware} i FUNCTION FACTORY DEFAULT USER CHOICES DESCRIPTION UPSIDE MEK Series Up tp 64 characters to define the UPS Use this function to uniquely identify the UPS in your network configuration Battery install date Date of manufacture Date of battery replacement day/monthiyear XRIXXKXXX Enter the current date when replacing batteries Battery life in days 1828 Up to 8 characters At first battery replacement, reset to reflect actu
ae. PRODUCT WARRANTY iV LIMITED PRODUCT WARRANTY Para Systems inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials of workmanship for a period of three years from the date of manufacture. For equipment sites within the United States and Canada. this warranty covers repays or replacement of defective equipment at the discretion of Para Systems.
DECLARATION OF CONFORMITY Application of Council Directive(s): 8/336/EEC, 723/EEC Standard(s) to which Conformity is declared: ENS0091.2, EN60S55-2, EN61000-3. ENS0091-1 Manufacturers Name: Para Systems Ane. (Minuteman Power Supplies Manufacturer's Address: 1455 Le May Drive Middleman Carroll ton. Texas 75007 USA Type of Equipment: Uninterruptible Power Supplies Mode] No: MBK 300YYY. MBK 320YYY, MRK 520YYY. MBK 680YYY. Year of Manufacture: Beginning September 1.
