Federal! Communications Commission (FCC) Statement This equipment has been tested and found to comply vita the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radii frequency energy and, if not installed and used in accordance vita the instructions, sy cause harmful interference to radio communications.
MINUTEMAN UNINTERRUPTIBLE POWER SUPPLIES : LE OF CONTENTS / MBK Series User's Manual 1. Introduction n Controls and Indicators Installation pow Operation i Troubleshooting Replacing the Battery hE Obtaining Service Specifications © © Configurable Parameters & Settings 10. Limited Product Warranty Thank you for purchasing a Minuteman power protection product. if has been designed ana manufactured to provide many years of trouble free service IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS ! .
WARNING: Changes or modifications to this unit not expressly approved by the A party responsible for compliance could void the users authority to operate the equipment : . Receiving Inspection After removing your Minuteman UPS from its carton, it shooed be inspected for damage that may nave occurred in shipping. Immediately notify the carrier and place of purchase if any damage is found. Warranty claims for damage caused by the carrier will not be honored.
MBK Series Uninterruptible Power Supply Users Manual TA ros AND PAV INDICATORS | FRONT PANEL online Front panel 1, | Press and release the afforestation button after one beep to turn the unit on or off O {see section online on battery Interlace Port (MBK 520 & 680 nly) no Ou SW JESSE Sen Rear panel REAR PANEL (120 vac models shown) The modular connectors are-used for single fine telephone surge protection (see section 3) The computer interface port is for UPS monitoring and control (see section 3) The site
Aaron 3\/ INSTALLATION PLACEMENT Install the UPS in a temperature controlled environment that is free of conductive contaminants. Select a location which will provide good ar circulation for the UPS at ail times. Avoid locations near heating devices, water of excessive humidity, or where the UPS 1s exposed ta direct sunlight.
(4\ / TURNING THE UNIT ON/OFF eee es tie On / Off / Test Switch Press ana release the switch after one beep to tur the unit on and supply power to the 15d. The load are immediately powered while the UPS runs a 5 second self fest.
USER NOTES <> J Rear Panel Switch Functions During normal AG operation the rear panel switch may be used to change the low voltage transfer level. This voltage is the voltage al which the unit switches from normal operation to battery mode operation The transfer point is changed by pressing and holding Whe switch until the switch level desired is achieved.
oe AT ! / EE troubleshooting TROUBLESHOOTING CHART . Pa Symptom Possible Cause What Off / Tet button not Crass On bullpen momentarily, UPS will not turn on pushed {one beep) to start UPS UPS operates in . Reset circuit breaker by pressing battery mode only, Input AC breaker is ripped the plunger back in. \f circuit even though there is breaker trips after UPS starts up, normal AC present reduce the load on the UPS The Site Wiring Fault LED Ruminated Incorrect service wiring Have a qualified electrician corr
era w Lacing THE BATTERY [AV REPLACING THE BATTERY The MBK Series UPS has an easy to replace hot-trappable battery. Please read the following warning statements before attempting to service the battery.
INNING SERVICE av 1F THE UPS REQUIRES SERVICE 1.Use the TROUBLESHOOTING section 5 to eliminate obvious causes. 2.Verify that no circuit breakers are tripped. A tripped circuit breaker is the most comment ‘problem. 3 Call your dealer for assistance. If you cannot reach your dealer. ot if he cannot resolve the problem. call or FAX Minuteman Technical Support at the following numbers: Voice phone (972) 446-7363. FAX line (572) 446-901}.
A CONFIGURABLE PARAMETERS EN /B SETTINGS {These items require optional software or hardware) i FUNCTION | FACTORY DEFAULT USER CHOICES DESCRIPTION PUDS MBK Series Up tg 64 characters 10 | Use this function to uniquely define the UPS identify the UPS in your network configuration Battery install | Date of manufacture Date of battery re| Enter the current date when gate placement replacing battened semimonthly KXIXXUXAXK Battery fife in | 1826 Up to 5 characters Al first battery replacement, gays reset to ref
a PRODUCT WARRANTY Vi LIMITED PRODUCT WARRANTY i Para Systems inc. (Para Systems) warrants this equipment, when properly applied : and operated within specified conditions, against faulty materials or workmanship for a period of three years from the date of manufacture. For equipment sites within the United States and Canada, this warranty covers repave or replacement of defective equipment at the discretion of Para Systems.
DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC, 723/EEC Standard(s) to which Conformity is declared: EN50091-2, EN60335-2, EN61000-3 ENS0091-1 Manufacturer's Name: Para Systems#inc.
