User Manual

NCSP3

1. Select the desired Zone. Press the "Mode" button to

switch to "Heat" mode.

• Heating

2. Press the "Source" button to select between Gas and

Electric.(Available Heat sources depend on Floor Plan)

3. Use the "Set" up and down arrows to set the desired

temperature for the zone.

4. Press the "Fan" button to switch between Off, Low, High

and Auto. (Off is not available in Electric Heat Source.)

Auto Mode will automatically switch between Cool and Heat

modes to reach the desired Set temperature.

(Heat Mode is only available in Zones with Heat Mode selected on

Floor Plan).

• Auto

1. Select the desired Zone. Press the "Mode" button to switch to

"Auto" mode.

2. Use the "Set" up and down arrows to set the desired temperature

for zthe zone.

3. Press the "Fan" button to switch between Off, Low, High and Auto.