User Manual

JRVCS1

INSTALLATION

It’s a good idea to read all of the instructions before beginning the installation. We recommend

having your Jensen JRVCS1 installed by a reputable RV dealership

Tools and Supplies

You will need these tools and supplies to install your JRVCS1:

 Phillips screwdriver

 Wire cutters and strippers

 Electrical tape

 Crimping tool

 Volt meter/test light

 Fork Crimp connectors

 10 gauge wire for power and slide connections

 14 and 18 gauge wire for all other connections

 Four #8 PH (0.164” x 0.75”) screws for the DC

 Six #8 PH (0.164” x 1.0”) screws for the BCM

Disconnecting the Battery

To prevent a short circuit, be sure to turn off 12V power and remove the negative (-) battery

cable prior to installation.

Selecting the Mounting Location

Select a mounting location, taking care to avoid the following:

 Places exposed to heat-radiating appliances such as electric heaters

 Adjacent to other equipment that radiates heat

 Poorly-ventilated or dusty places

 Moist or humid locations

Mounting the Display Commander (DC)

 Use the mounting hole diagram to measure and cut a mounting hole

 Route power wires through the hole and connect

 Check and ensure correct operation

 Mount the unit using four #8 PH (0.164” x 0.75”) screws

 Attach Trim ring

CUTOUT FOR DISPLAY COMMANDER (DC)

NOTE: Before cutting the mounting hole, make sure the area behind the mounting

location is clear of wires, fuel and vacuum or water lines.

格式化: 字型: 粗體

格式化: 左 0 字元

刪除:

刪除:.

刪除: