User's Manual

LTD-1021 User's Manual Appendix
LTD-1021 User Manual Page B-1
B Wall mounting
It is possible to wall mount the LTD-1021, since it supports standard VESA
mounting. The mounting holes are 100mm apart from each other in a square.
To mount the LTD-1021 you need to first remove the stand:
1. Remove the four screws
for the stand
2. The rear of the LTD-1021
is now plain
3. Follow the instruction
manual for the VESA
mounting bracket you
bought separately on how
to install it
4. If you don’t have a VESA
mounting bracket it’s also
possible (but not
recommended) to use the
two holes on the rear of
the LTD-1021
5. If you use the two holes on the rear of the LTD-1021, make sure that
the nails or screws you use on the wall are strong enough and
supported well. The LTD-1021 is quite heavy and might fall off if the
mounting is done badly.
Notice: Warranty will be void if you wall mount the unit and it falls
down. This would be considered bad craftsmanship on
the mounting, so make sure that the wall and screws are
all strong enough to support the LTD-1021.