User's Manual

Before you begin LTD-1021 User's Manual
Page 2-4 LTD-1021 User Manual
2.3 Default Conditions
The default settings should be suitable for most people, but if you would like
to adjust Brightness, Contrast, Color, Sharpness, Color temperature or fine
tune TV channels it’s possible to do so:
1. Turn on the LTD-1021
2. Click the TV button on the remote control
3. Click the Menu (2) button on the remote control
4. Click the Down (6) arrow to select ‘PICTURE’ and press
‘ENTER’
5. You may now select one of the several picture enhancing modes
by moving up and down, click the ‘ENTER’ button to select.
6. Once you select an option and finish adjusting it, click the
‘RETURN’ (8 ) button to return to previous menu, click once
again to leave the Menu or wait a few seconds.
To restore default settings go to the ‘Picture’ submenu (once you are in TV
mode and click the Menu button), select the ‘Reset’ option to set the LTD-
1021 to factory default settings.
2.4 Picture adjustment
The default settings in Chapter2.3 can easily be changed to fit your individual
need. Below these modes are described:
Brightness Make the picture brighter or dimmer, default is 100.
Contrast A higher contrast makes the distinctions between different
colors even greater (will result in picture degrading), a lower
contrast makes all color become quite similar and also
degrade the picture. The default is 50.
Color A lower number reduced the amount of color (almost black
and white), while a higher number makes the colors very
bright, default value is 50.
Tint Low number makes the picture reddish; High number makes
the picture greenish, default is 50.
Sharpness Adjust the sharpness, default is 50.