User's Manual

If you want to stop the motors off, please press “Select” + “O” simultaneously, the motor vibrate
will be off. Press the buttons again, motors vibrate will be On.
Note: when under vibration Off mode, Logo LED will not change color any more.
7. Force connect function:
When there are two or more than two RF controllers gaming meanwhile, you
can thru force connect function to choose your favorite RF controller.
Press “Select” + △ simultaneously, Mode LED will lighting, then press “FC”
button in receiver, it will be application within 15 seconds.
9. Sleeping function:
Case 1: The RF controller will automatically go to sleep after approximately 10
minutes of not using any buttons. In this case, Mode LED will turn off.
Case 2: after connection ok, then RF receiver power off, and the pad still
power on, Mode LED will flash for 30minutes, RF controller will get into
sleeping mode.
Case 3: when RF pad power on but RF receiver power off, Mode LED will flash
for 15minutes, RF controller will get into sleeping mode.
Note: when wheel get into sleeping mode, all LEDs will turn off.
10. Wake up
To power again after RF controller sleep, press any or L3, R3 or Start button.
Note: If RF pad cannot searching any signal from RF receiver in 30minutes,
RF controller will get into sleeping mode again.