User's Manual

User Manual: Field Transmitter

2.5.1 Battery Installation/Replacement Procedure

1. Unscrew the outer cover from the side closest to the mounting bosses.

2. If replacing a battery, remove Qty. 3 M4x6mm Button Head screws from standoffs on battery holding board

using a 2.5 mm hex key tool. Disconnect the battery harness from the connector and remove the battery

pack. Skip this step and proceed to step 3 if a battery is not present in the device.

3. Slide replacement battery pack into enclosure according to the battery pack size in Figure 17: Battery

Compartment Exploded View below.

4. Install Qty. 3 M4x6mm screws to secure the battery using a 2.5 mm hex key tool.

5. Plug battery harness into connector.

6. Hand-tighten the outer cover onto the PCU body.

Figure 17: Battery compartment exploded view

WARNING: Battery replacement may be performed in the field without a hot work permit.

WARNING: Only battery packs provided by Syscor are compatible with this device.

WARNING: Batteries are not rechargeable.

WARNING: Follow local restrictions and guidelines for disposal of lithium batteries.

2.6 Antenna Placement Considerations

Antennas are connected via an industry standard N-Type connector. The antenna may be remotely mounted

using an N-type extension cable or screwed in directly.

Figure 18: Antenna connection

Battery harness