Data Sheet
SBF508M‐21V Datasheet
Confidential Syntronix Corporation 6
RP-PJ8
7. Label and compliance information
An exterior label on OEM’s end product can use wording such as the following: "Contains
Transmitter Module FCC ID: 2AUBRB5JPB
8. Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module grantee on the required
number of channels, modulation types, and modes, it should not be necessary for the
host installer to re-test all the available transmitter modes or settings. It is
recommended that the host product manufacturer, installing the modular transmitter,
perform some investigative measurements to confirm that the resulting composite
system does not exceed the spurious emissions limits or band edge limits (e.g., where
a different antenna may be causing additional emissions).
b) The testing should check for emissions that may occur due to the intermixing of
emissions with the other transmitters, digital circuitry, or due to physical properties of
the host product (enclosure). This investigation is especially important when integrating
multiple modular transmitters where the certification is based on testing each of them in
a stand-alone configuration. It is important to note that host product manufacturers
should not assume that because the modular transmitter is certified that they do not
have any responsibility for final product compliance.
c) lf the investigation indicates a compliance concern the host product manufacturer is
obligated to mitigate the issue. Host products using a modular transmitter are subject
to all the applicable individual technical rules as well as to the general conditions of
operation in Sections 15.5, 15.15, and 15.29 to not cause interference. The operator of
the host product will be obligated to stop operating the device until the interference
have been corrected.
Additional testing, Part 15 Sub part B disclaimer The final host / module combination need
to be evaluated against the FCC Part 15B criteria for unintentional radiators in order to be
properly authorized for operation as a Part 15 digital device.
FCC Warning:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This device complies
with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation
OEM integrators and end users must be provided with transmitter operating conditions for
satisfying RF exposure compliance.