User`s guide

8

•
For 2.5” Hard Disk:
a
Placetheharddiskinthe2.5"DiskHolder(TypeC,soldseparately),and
thentightenthe2.5"screwstosecuretheharddisk.
b
Slidethe2.5"DiskHolderintotheharddrivebay,andpushitalltheway
untiltheharddiskisconnectedtotheSATAconnector.SecuretheDisk
Holderwiththeprovidedscrews.
Thedisks’positionsarenumberedasshownbelow.
1
2
1
2
Important:
Makesurethetrayispushedinalltheway.Otherwise,theharddisk
mightnotbeabletofunctionproperly.
3
Replacetheuppercase,andtightenthescrewsonthebackpanel.
Note:
IfyouwanttosetupaRAIDset,itisrecommendedthatallinstalledhard
disksareofthesamesizetomakethebestuseofharddiskcapacity.