SYNLawn Artificial Grass Care and Maintenance Manual
Care and Maintenance Manual
SCM.v140324 | 02/18/2019 | Page 4
The second group of cleaners must be applied sparingly with care taken to avoid
penetration of the agent beneath the turf are the following:
Mineral spirits or a grease spot remover like perchlorethylene (dry cleaning solution) of the
type sold by most variety stores and supermarkets. In general, cleansers in this category
should handle most oil-based stains including:
Asphalt and tar
Cooking oil
Floor wax
Motor oil & grease
Ballpoint ink
Suntan oil
Chewing gum
Shoe polish
Lipstick
Paran wax
Nail polish
Crayon
Caution: Mineral spirits and other petroleum based solvents are ammable.
Do not smoke or permit open ames near where these are being used.
Be sure the area is well ventilated where solvent cleaners are used.
C. Animal Waste
Although all SYNLawn
®
products are pet friendly, there is additional maintenance necessary
to keep odors to a minimum. Allow waste to dry and then dispose. Consider use of
products such as Simple Green or Pro-vet-logic that are pet safe. Depending on the
amount of usage and number of dogs, enzyme neutralizers may also be helpful to control
odors. Neutralize with mixture of white distilled vinegar in an equal amount of water. Some
odor control inlls require ushing with water and some do not, so it’s important to ask
for specic recommendations from your local SYNLawn dealer in accordance with the inll
product used for your installation.
D. Mineral deposits
Apply a mixture of white distilled vinegar in an equal amount of water to grass and lightly
brush. Flush thoroughly with water after application.
E. Chewing gum or tree sap
In addition to dry cleaning uid, chewing gum and tree sap can be removed by freezing.
Aerosol packs of refrigerant are available from most carpet cleaning suppliers for this
purpose, or dry ice can be used. After freezing, scrape with a knife.
D. Mineral deposits
Apply a mixture of white distilled vinegar in an equal amount of water to grass and lightly
brush. Flush thoroughly with water after application.