User Manual

16) Allow welds to cool. Deburr welds and paint to prevent corrosion.
17) Installation on the passenger side is complete. Installation on the driver’s side follows the same
procedure as the passenger side. The only difference is the exhaust makes for slightly less room to work
in. Installation can be done with exhaust in place, however for easier installation, remove factory Y-
pipe to gain clearance.
18) If desired, remove the factory Y pipe using the factory service manual as a guide. You can also
reference PPM-5017 instructions for details.
19) Follow the same procedure used on the passenger side.
20) Reinstall all lower control arm bolts and torque to mfg or stock specifications (125 ft-lbs for OEM or
Synergy)
Installation is Complete