User Manual

4) Install the washer cap over the bushing as shown.
5) Install onto vehicle. Ensure taper is fully seated in knuckle and not hindered by boot / washer cap
assembly. If there is any doubt, remove washer cap and re-install. In many applications, the washer cap
cannot be used in order to have proper taper engagement and account for steering ackerman.
6) Be sure tie rod ends are in a neutral position with the wheels straight during install. Torque tie rod end
to mfg specs. (70-75 ft lbs in most applications)
7) Wipe off any excess grease from install.
Installation is Complete