User Manual

90°
IMPORTANT: Lightly sand carbon
rod with 400 grit sandpaper before
applying epoxy. Use 30-Minute or
longer curing Epoxy. Quick or 5-Minute
Epoxy is not recommended.
TIP: Insert tail control rod into the
tail rod support prior to installing the
second linkage.
Use care when configuring the
flybarless controller to verify tail pitch
arm is 90 degrees at center tail position.
3-5 degrees of pitch compensation
against torque is recommended for
optimal flybarless behavior.
516-412
Tail Push Rod 525mm
516-411
Tail Push Rod End 2mm
516-411
Tail Push Rod End 2mm
107-099
Plastic Link
107-099
Plastic Link
106-965
Tail Push Rod Sleeve
516-401
Tail Boom - 578mm
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
12 | TAIL SERVO
33
Rev 1.0M
TAIL CONTROL ROD