User Manual

90°
13.5mm
Use care when configuring the
flybarless controller to verify tail
servo arm is as close to 90 degrees
as possible. 13.5mm servo arm is
recommended for optimal tail geometry
and throws.
Synergy does not supply with the kit:
servos, servo horns, and servo horn
bolts.
Apply BLUE and RED threadlocker
where indicated.
!
IMPORTANT: Pre-drill servo arm
with 2.5mm or 3/32” drill bit before
installing Pivot Ball.
MINIMUM TAIL SERVO TORQUE:
60 oz/in or 4.3 kg/cm.
Use a high-voltage brushless or coreless
760us narrowband tail servo for
optimal tail performance.
*NOT INCLUDED*
107-110
Pivot Ball
2.5mm x 4.5mm (3)
100-266
M2.5x6 Socket Head (4)
100-254
M2.5 Standard Nut
106-115
Servo Hold Down
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
12 | TAIL SERVO
32
Rev 1.0M
TAIL SERVO INSTALLATION