User Manual

x12
x12
Apply BLUE threadlocker where
indicated.
90°
Synergy does not supply with the kit:
Servos, servo horns, and servo horn
bolts.
Use care when configuring the
flybarless controller to verify servo
arms are near or at 90 degrees. Use
small trim adjustments if necessary.
NOTE: The Synergy 516 swash and
head geometry has a high cyclic ratio
for quick cyclic response. Reduction of
the flybarless controller’s cyclic ring
may be necessary in order to prevent
binding of the swash plate linkages at
collective extremes.
NOTE: Mini cyclic servos with a
mounting tab spacing of 42.6mm are
recommended.
MINIMUM SERVO TORQUE: 100 oz/in
or 7.2 kg/cm.
Use high-voltage brushless or coreless
cyclic servos for optimal performance.
42.6mm
100-268
M2.5x8 Socket Head
100-274
M2.5 Washer
NOT INCLUDED (x3)
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
10 | CYCLIC SERVOS
30
Rev 1.0M
CYCLIC SERVO INSTALLATION