User Manual

Depending on the flybarless unit and
servos chosen, optimal geometry can
be achieved using servo arms with ball
linkages placed at a distance of 15mm
to 17mm from the center of rotation.
NOTE: Turnbuckle linkages have
reverse threads on one end. The final
length may vary slightly per individual
model.
For optimal geometry, all servo linkages
should be equal in length.
13.5-17mm
x3
x3
11.5mm
!
IMPORTANT: Apply RED threadlocker
to all pivot balls. Heat may be required
for removal.
IMPORTANT: Pre-drill servo arm
with 2.5mm or 3/32” drill bit before
installing the Pivot Ball.
107-110
Pivot Ball
2.5mm x 4.5mm (3)
*NOT INCLUDED*
107-099
516 Plastic Link (6)
107-028
Turnbuckle Link Rod 28mm (3)
100-250 M2.5 Regular Nut
(3)
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
10 | CYCLIC SERVOS
29
Rev 1.0M
CYCLIC ARMS AND LINKAGES