User Manual

x2
TIP: Use extreme pressure synthetic
grease on all thrust bearings for optimal
performance. Boto-Lube Part BD-001
IMPORTANT: Full disassembly is
required. Apply RED threadlocker to
both tail grip pivot balls and bolts.
!
!
!
GREASE THRUST BEARINGS
!
THRUST BEARING TIP
Use the tail hub to determine inside and
outside races:
Loose Fit
(Large Inside Diameter)
INSIDE OUTSIDE
Tight Fit
(Small Inside Diameter)
INSIDE
OUTSIDE
IMPORTANT: Apply threadlocker
to inside threads of the Tail Hub
rather than the Socket Head bolt.
This will prevent threadlocker from
contaminating the radial bearing,
causing it to seize.
NOTE: Tail Blade Grips have in/out play
by design. Do not attempt to add shims
to the assembly in a effort to remove
play.
108-503
5x10x3 Radial Bearing
106-501
5mm Shim
515-525
HD Tail Blade Grip
107-106
Pivot Ball
100-354
M3 Washer
615-324
HD Tail Rotor Hub
100-308
M3x8 Socket Head
108-503
5x10x3 Radial Bearing
100-308
M3x8 Socket Head
100-354
M3 Washer
108-511
5x10x4 Thrust Bearing
!
NOT 107-110
01 | INTRODUCTION
02 | FRAME
03 | LANDING GEAR
04 | BELT TENSION ARM
05 | MAIN DRIVE
06 | BOOM INSTALLATION
07 | TAIL ASSEMBLY
08 | SETTING BELT TENSION
09 | SWASH PLATE
10 | CYCLIC SERVOS
11 | ANTI-ROTATION GUIDE
12 | TAIL SERVO
13 | MAIN HEAD
14 | PITCH LINKAGES
15 | MOTOR INSTALLATION
16 | BATTERY TRAY & CANOPY
17 | BLADE INSTALLATION
18 | COMPLETE MODEL
07 | TAIL ASSEMBLY
25
Rev 1.0M
TAIL - HUB AND GRIPS